67C3K11 7-301234567893. Install the bolt 5, and then tighten it.4. Install the self-locking nut 6 onto thethrough tube 4, and then tighten it to thespecified torque.5. Install the ground lead(s) 7 and bolts 8to the brackets.6. Install the anode 9 and then tighten thebolts 0 to the specified torque.7. Install the stoppers A and nuts B.8. Install the trim sensor cam C, and thentighten the screw D to the specifiedtorque. (R model with PTT)È D modelÉ PTT modelÊ R model with PTTNOTE:Adjust the trim sensor cam after installing thePTT unit. To adjust the trim sensor cam, see“Adjusting the trim sensor cam (R model)” (7-32).Installing the hydraulic tilt unit1. Tilt the outboard motor to the fully upposition, and then support it with the tiltstop lever.WARNINGAfter tilting the outboard motor up, besure to support it with the tilt stop lever.S67C7053È ÉAA9AA32036ÊB77 7881CDÊB45AAAAÈT R..Self-locking nut 6:22 N·m (2.2 kgf·m, 16.2 ft·lb)Anode bolt 0:8 N·m (0.8 kgf·m, 5.9 ft·lb)Trim sensor cam screw D:2 N·m (0.2 kgf·m, 1.5 ft·lb)Grease nipple:3 N·m (0.3 kgf·m, 2.2 ft·lb)S67C7123Clamp bracket and swivel bracket
