67C3K11 6-20123456789NOTE:After connecting the shift rod 8, check thatthe gear shift operates properly.6. Install the anode 0, trim tab A, andcooling water inlet covers B, and thentighten the trim tab bolt C and coolingwater inlet cover screw D to the speci-fied torques.7. Install the propeller E and propeller nutF. Place a block of wood between theanti-cavitation plate and propeller to keepthe propeller from turning, and thentighten the nut to the specified torque.WARNING• Do not hold the propeller with yourhands when loosening or tightening thepropeller nut.• Be sure to disconnect the battery cablesfrom the battery and remove the clipfrom the engine shut-off switch. (E andW model)NOTE:If the grooves in the propeller nut F do notalign with the cotter pin hole, tighten the nutuntil they are aligned.8. Fill the lower unit with gear oil to the cor-rect level.Screwed in length a:8.0–9.0 mm (0.31–0.35 in)T R..Trim tab bolt C:18 N·m (1.8 kgf·m, 13.3 ft·lb)Cooling water inlet cover screw D:4 N·m (0.4 kgf·m, 3.0 ft·lb)S67C60597a9688S67C6060572LTBBACD0T R..Propeller nut F:39 N·m (3.9 kgf·m, 28.8 ft·lb)Recommended gear oil:Hypoid gear oilAPI: GL-4SAE: 90Gear oil quantity:430 cm3(14.54 US oz, 15.17 Imp oz)S67C6061DE FS67C6108Drive shaft and lower case
