67C3K11 8-201234567893. Measure the CDI unit 3 output peakvoltage. Replace if below specification.NOTE:• To prevent the engine from starting whencranking it, be sure to disconnect all sparkplug caps.• Do not remove the clip from the engineshut-off switch.• When using the manual starter to crank theengine to measure the output peak voltage,turn the engine start switch to “ON” (Wmodel).• When using the manual starter to crank theengine, the voltage values may varydepending on the speed at which thestarter handle is pulled.• Be sure to check the charge coil and pulsercoil before measuring the CDI unit outputpeak voltage.4. Disconnect the special service tool 2and connect the ignition coil coupler.Test harness (2 pins) 2:90890-06867S67C8048B/OOB/OOB/WOB/WB/YOB/Y15161314G/WG231#1#2#3CDI unit output peak voltage(reference data):#1: Orange (O) –Black/orange (B/O)#2: Orange (O) –Black/white (B/W)#3: Orange (O) –Black/yellow (B/Y)r/min LoadedCranking 1,500 3,500DC V 120 170 170Ignition and ignition control system / Engine electric control system
