ABB OmniCore IRB 6720 Product Manual

Restoring the balancing device and removing the Hydraulic press equipment, balancing deviceNoteActionUser instructions are enclosed with thetool.Restore the balancing device and removethe press equipment according to instruc-tions for the press equipment.xx0900000813Go to the user instructions enclosed withthe press tool.DANGERHandling the tool incorrectly will causeserious injury.Read and follow enclosed user instructionsfor the tool.Hex socket head cap screw: M10x25 8.8-A3F.Apply flange sealant and refit the coverplate on the back of the balancing device.1Tightening torque: 50 Nm.Flange sealant for conical fittings: Loctite5400 (or equivalent Loctite 577).xx2200001330Concluding procedureNoteActionDANGERMake sure all safety requirements are metwhen performing the first test run. See Testrun after installation, maintenance, or repairon page 100.1238 Product manual - IRB 67203HAC085697-001 Revision: C© Copyright 2023 ABB. All rights reserved.5 Repair5.3.3 Replacing the rear bearings on the balancing deviceContinued