Canon ImageRunner iR8500 Series Service Manual

Also see for ImageRunner iR8500 Series: Function guide Service manual Servise manual Service manual

Contents

Chapter 1717-185MODEL-SZ Switching regular resized display and ADF document size detection10: AB (6R5E) [Default]1: INCH (5R4E)2: A (3R3E)3: AB/INCH (6R5E)FIX-TEMP Setting the down sequence start temperature for thick paper mode10: 194 deg C1: 189 deg C (default)2: 184 deg CFUZZY Use it to turn on/off fuzzy control and to make environment settings.1MEMO:- The selection will affect pre-transfer, transfer, and separation chargingcurrents.- Selecting 1 through 3 will make the operation independent of the envi-ronment sensor.0: fuzzy control ON (default),1: low humidity environment mode (current level lower than standard),2: normal humidity environment mode,3: high humidity environment mode (current level higher than standard)CNT-W/PR Use it to turn ON/OFF the mechanism to change density during printing (PDLinput).10: correct target value to enable change of density during printing (default)1: do not change density during printingCONFIG Selecting several types of firmware installed on the hard disk and switchingthe country, language, and paper size type of this machine1XXYYZZAAXX: Country (UP), YY: Language (ja), ZZ (00) Destination(00:CANON 01:OEM), AA (00): Paper size type (00:AB 01:Inch 02:A03:All size)1) Select .2) Select an item to reverse its display. Then press the + or - key to change thecontents.3) Each time the + or - key is pressed, the contents change sequentially.4) Display the intended contents at all items and press the OK key.5) Turn the main power switch OFF and ON.TR-SP-C1 Use it to set the transfer/separation output setting when the right deck isselected, thereby preventing faults otherwise occurring.10: setting for plain paper (default)1: setting for recycled paper2: setting for tracing paperTR-SP-C2 Use it to set the transfer/separation output setting when the left deck is used,thereby preventing faults otherwise occurring.10: setting for plain paper (default)1: setting for recycled paper2: setting for tracing paperTR-SP-C3 Use it to set the transfer/separation output setting when the cassette 3 is used,thereby preventing faults otherwise occurring.10: setting for plain paper (default)1: setting for recycled paper2: setting for tracing paperTR-SP-C4 Use it to set the transfer/separation output setting when the cassette 4 is used,thereby preventing faults otherwise occurring.10: setting for plain paper (default)1: setting for recycled paper2: setting for tracing paperTR-SP-MF Use it to set the transfer/separation output setting when the manual feed trayis used, thereby preventing faults otherwise occurring.10: setting for plain paper (default)1: setting for recycled paper2: setting for tracing paperCOPIER > OPTION > BODYSub-item Description Level