Chapter 1717-4917.3.8 FEEDER0008-9074/ iR8070The indication will be '0' while the machine is in operation (reading an original).T-17-38P029 reversal sensor adjustmentP030 manual feed registration sensor adjustmentP031 pre-cycle end sensor adjustmentP032 separation motorAddress Bit Description Notation RemarksP001 0 feed motor drive clock M21 not used2 feed motor clock LB M23 pickup motor clock LB M14 not used5 delivery reversal motor clock LB M36 large/small identification sensor signal PI3 1: paper present(large)7 A4R/LTRR identification sensor signal PI4 1: A4RP002 0 pickup motor drive clock signal M11 pickup motor mode signal M12 pickup motor CW/CCW signal M13 pickup motor enable output M14 not used5 feed motor enable output M2 1: enable6 pickup clutch drive signal CL1 1: ON7 locking solenoid signal SL1 1: attractedP003 0 serial communication transmission (TxD0)1 image leading edge signal2 serial communication reception (RxD0)3 EEPROM data output transmission (TxD1)4 EEPROM clock (SCK0)5 EEPROM chip select6 not used7 not usedP004 0 original width VR signal VR1 (AN0)1 post-separation sensor analog signal S3 (AN1)2 read sensor analog signal S2 (AN2)3 delivery reversal sensor analog signal S1 (AN3)4 not used5 not used6 not used7 not usedP005 0 external WDT clock output1 D/A data output2 D/A clock output3 D/A load signal4 not used5 not used6 not used7 not usedAddress Bit Description Notation Remarks
