Chapter 44-29F-4-454.7.2.8 When Replacing the Main Controller PCB0008-4993iR105i/iR105+ / iR9070 / iR85+ / iR8070If you are replacing the main controller PCB, be sure to transfer thefollowing components from the old to new PCB:[1] BootROM[2] HDD[3] image memory (SDRAM)[4] counter memory PCBF-4-46If the user uses NetSpot Accountant (NSA) in Combination with aCard ReaderThe SDRAM of the main controller retains card ID used by NSA. If youhave replaced the main controller, you will have to download the carddata from NSA once again to permit NSA to perform statisticaloperations.If you have formatted the HDD and downloaded the system software,you will have to go through a specific set of steps:1) Format the HDD.2) Download the system software.3) Make the following selections:COPIER>FUNCTION>INSTALL>CARD.4) Enter a card No.Enter the first of the numbers that will be used for group control,and press the OK key (e.g., if you are planning to use cards fromNo. 1 thorough No. 100, enter '1').5) turn off and then on the main power.6) Check the count control mechanism in user mode.system control setup>group ID control>count controlcheck to see as many as 'ID00000001 through ID00001000' have beenprepared.7) Set the IP address in user mode.system control setup>network setup>TCP/IP setup>IP addressSet 'IP address', 'gateway address', and 'sub net mask'.8) Enter a number of your choice in user mode.system administrator info setup>system control group ID>systemcontrol ID No.9) Hold down the control panel power switch for 3 sec or more.10) Go through the instructions on the control panel for shut-downsequence so that the main power switch may be turned off.11) Turn off the main power switch. Wait for 3 sec or more, and turn itback on.Unless you have registered 'system control group ID' and 'system controlID No.', you will not be able to register cards for the device in the courseof Net Spot Accountant setup work.12) Download the card ID.Keep the machine in a standby state < and download the card ID tobe used from the NSA>13) Check the count control particulars in user mode.system control setup>group ID control>count controlSee that only the downloaded ID data is shown.14) Check to see that the operation is normal.Make copies using a user card that has been registered using the NSA,and check to see that the count of the card in question has beenincremented correctly.4.7.3 Boot ROM4.7.3.1 Removing the Rear Cover0008-2685iR105i/iR105+ / iR90701) Remove the 11 mounting screws [1], and detach the rear cover [2].F-4-474.7.3.2 Removing the Rear Cover0008-9359iR85+1) Remove the 11 mounting screws [1], and detach the rear cover [2].[1][1][2][2][3][1][2][1][2][3][4][1][1][2]
