Chapter 22-31F-2-11910) Disconnect the connector [1], and release the locking lever [3] of thepre-transfer charging assembly [2]; then, take out the pre-transfercharging assembly.Using alcohol, clean the pre-transfer charging wire.F-2-12011) With the lock released, slide in the primary charging assembly, andconnect the connector.Check to make sure that the solvent is fully dry.12) With the lock released, slide in the pretransfer charging assembly,and connect the connector.F-2-121- Check to make sure that the solvent is fully dry.- Check to make sure that the one-way arm [1] of the pretransfercharging assembly is on the eccentric cam [2].13) Mount the primary charging assembly cover and the pre-transfercharging assembly cover with a screw (1 pc. each).14) Close the front cover.2.2.16 Mounting the Pickup Assembly0007-6647iR105i/iR105+ / iR90701) Shift down the lever [1] in the direction of the arrow, and remove thepickup roller releasing spacer [2].F-2-122Close the manual feed tray unit [3].2) Open the right upper cover and the right lower cover, and push therelease buttons of the front deck (right) and cassette 3/4; then, slidethem halfway out.3) Remove the three pickup roller releasing spacers [1].Close the upper vertical path cover [2] and the lower vertical pathcover [3].Fit the front deck (right) and the cassette 3/4 back in.F-2-1234) Press the releasing button of the front deck (left), and slide it to thefront.Secure the deck locking plate [1] to the front deck (left) with an RStightening screw [2] (M4x10; white).Close the front deck (left).[1][2][2][3][1][1][2][2][3][1][1][2][3]
