Chapter 1616-2T-16-1Code DescriptionE000 The temperature of the fixing assembly is abnormally high.E001 The over-rising in temperature of the fixing assembly is detected.E002 The rise in temperature of the fixing assembly is faulty.E003 The fixing temperature is too low after a standby state.E004 The fixing assembly is faulty.E005 The absence of the fixing web is detected.E010 The rotation of the main motor is faulty.E012 The rotation of the drum motor is faulty.E013 The lock of the waste toner feed screw is detected.E014 The rotation of the fixing motor is faulty.E015 The rotation of the pickup motor is faulty.E019 The waste toner case is full, or the waste toner case full sensor is faulty.E020 The difficulty providing toner inside the hopper developing assemblies is detected.E025 The toner feed motor inside the hopper is faulty.E032 The counter of the copy data controller or the NE controller is faulty.E043 The rotation of the side paper deck main motor is faulty.E051 There is an error in the detection of the horizontal registration home position.E065 There is an error in the high-voltage output to the primary charging assembly.E067 There is an error in the high-voltage output.E068 There is an error in the high-voltage output to the separation charging assembly.E069 There is an error in the high-voltage output to the transfer charging assembly.E100 The BD PCB is faulty.E110 The rotation of the laser scanner motor is faulty.E111 The rotation of the laser motor cooling fan is faulty.E121 The rotation of the laser cooling fan (1/2) is faulty.E202 There is an error in the detection of the scanner home position.E204 There is an error in the detection of the image leading edge signal.E211 The rise in temperature of the scanning lamp heater is faulty.E215 The temperature of the scanning lamp heater is abnormally high.E218 The scanning lamp is not mounted properly.E219 The scanning lamp lifeE220 The lighting of the scanning lamp is faulty.E222 The rise in temperature of the scanning lamp heater is faulty.E240 The communication between the MCON and DCON is faulty.E241 The communication between the original orientation detection PCB and RCON is faulty.E243 The communication between the control panel PCB and MCON is faulty.E251 The rotation of the inverter cooling fan is faulty.E302 Shading errorE315 There is an error in image data.The reader controller PCB is faulty. The main controller PCB is faulty.E320 There is a time out error in the image reading processing.E400 Communication error with the ADFE402 The rotation of the ADF belt motor is faulty.E404 The rotation of the ADF delivery motor is faulty.E405 The rotation of the ADF separation motor is faulty.E410 The rotation of the ADF pickup motor is faulty.E412 The rotation of the ADF cooling fan is faulty.E420 The EEPROM is faulty. The ADF controller PCB is faulty.E602 There is an error on the hard disk.E604 The image memory is faulty or is inadequate.E609 There is an error on the HDD.E610 The HDD coding key is faulty.E710 There is an error in the initialization of the IPC.E711 There is an error in the IPC communication.E712 Communication error with the ADFE713 There is an error in the communication with the finisher.E717 There is an error in the communication with the NE controller.E719 There is a coin vendor error.E730 There is a PDL software error.E732 There is an error in the communication with the scanner.
