Chapter 1717-212T-17-216T-17-2171) Press the switch at the operating section long for the shutdown sequence and turn the main power switch OFF.2) Connect the network cable to this machine and turn the main power switch ON.3) Notify the system administrator that the machine has been installed to request network setup.4) Notify the system administrator of the network connection check plan and check the PING remote host address (IP address of a PC terminal in the usernetwork).5) Select the service mode (COPIER>TEST>NETWORK>PING), enter the IP address checked at Step 4 from the ten-key pad of the operating section,and press the OK key and the Start key.- Once the network has been connected normally, OK is displayed. (End)- If NG is displayed, check the connection of the network cable first. If the network cable is connected normally, do Step 6 and later. If the networkcable is not connected normally, repeat Step 5.6) Select the service mode (COPIER>TEST>NETWORK>PING), enter the loopback address *(127.0.0.1), and press the OK key and the Start key.- If NG is displayed, the TCP/IP setting of the local machine may be wrong. Return to Step 3 and check the setting again.- If OK is displayed, the TCP/IP setting of the local machine seems correct but the network controller (main controller circuit board) may be faulty.Check the controller at Step 7.*: Since the loopback address signal is returned before the network controller, the TCP/IP setting of the local machine can be checked.7) Select the service mode (COPIER>TEST>NETWORK>PING), enter the local host address (IP address of the local machine), and press the OK key.- If NG is displayed, the IP address of the local machine may be wrong or the network controller may be faulty. Check the IP address with the systemadministrator or replace the main controller circuit board.- If OK is displayed, there seem to be no problems about the network setting of the local machine or the network controller.Then the problem may be attributable to the user network environment. Report this to the system administrator and request action.COPIER>TEST>PGSub-item Description LevelTYPE Enter a test print type number and press the Start key for test printing. (After testprinting, be sure to return the number to 0.)0: Image from CCD (Ordinary print)[Default]1: Checker2: 17 tones (Error diffusion method [T0BIC])3: 17 tones (Dither screen method)4: Totally white 00H5: Halftone 80H (Error diffusion method [T0BIC])6: Halftone 80H (Dither screen method)7: Totally black FFH8: Horizontal line (space: 27 dots, line width: 40 dots)9: Horizontal line (space: 50 dots, line width: 60 dots)10: Horizontal line (space: 3 dots, line width: 2 dots)11: Halftone 60H (Error diffusion method [T0BIC])12: Halftone 60H (Dither screen method)13: Halftone 30H (Error diffusion method [T0BIC])14: Halftone 30H (Dither screen method)15 - 20: For development1TXPH Use it to switch between text mode and photo mode for test printing.10 to 4 [Default: 0]PG-PICK Selecting an output stage for test printing1: Cassette 1 [Default]2: Cassette 23: Cassette 34: Cassette 45: Side deck6: Manual feed7 - 8: Not used12-SIDE Setting the output mode for test printing0: Simplex [Default] 1: Duplex 1PG-QTY Setting the number of pages for test printing1 to 999 [Default: 1] 1COPIER>TEST>NETWORKSub-item Description LevelPING Checking the connection from this machine to the network (TCP/IP only)The network connection is checked when the machine has been installed and when theconnection has become faulty.1
