Chapter 22-27F-2-945) Remove the tape used to keep the tag in place, and open the top [1] ofthe fixing/ feeding assembly; then, remove the 2 fixing nip releasingscrews [2] at the front and rear.F-2-95Close the top of the fixing/feeding unit.2.2.13 Checking the Developing Assembly0007-6638iR105i/iR105+ / iR90701) Open the manual feed tray unit.2) Take out the developing assembly from the package that comes withthe machine.Turn the developing cylinder by hand to check it for scratches.3) Holding the developing assembly [1] as shown, mount it to themachine.F-2-96When mounting the developing assembly, fit it from a high position, andtake care not to bring the developing cylinder into contact with the plateof the developing assembly base.4) Connect the 2 connectors [1].F-2-975) Secure the developing assembly locking unit [1] with the 6 TP screws[2] (M4x6; black) that come with the machine.F-2-98Be sure that the developing assembly locking unit is firmly in contactand is free of displacement to avoid image faults. (Particularly, it mustnot ride overt the boss found at the bottom.)6) Fit the door tape of the manual feed tray cover with a screw (M4x8;w/ washer: black).(Keep the manual feed tray cover open).F-2-992.2.14 Mounting the Charging Assembly0007-2902/ iR85+1) Remove the screw [2], and detach the transfer/separation assemblyfront cover [1].[3] [2][1][2][1][1][1][2] [2][2][1][3][1][2]
