Chapter 1414-67F-14-16214.8.32 Position for the Cassette 3/4 PickupSolenoid (SL9/10)0008-8424/ iR85+ / iR8070Adjust the position using the screws [1] so that when [A] and [B] in thefollowing figure are operated and when the plunger of the pickup rollerreleasing solenoid is pulled, the distance from the bottom of each pickupunit to the bottom edge of the bushing of the roller support plate is 36±0.5 mm.F-14-16314.8.33 Position of the Side Paper Deck PickupRoller Releasing Solenoid0007-0648iR105i/iR105+ / iR9070Before removing the deck pickup roller releasing solenoid [1] from thesupport plate, make mental notes of the positions of the 2 fixing screws[2] of the solenoid with reference to the index on the support plate. (Or,mark the position of the solenoid on the support plate with a scriber.)If you are replacing the solenoid on its own, you must secure it in itsinitial position.F-14-16414.8.34 Position of the Side Paper Deck PickupRoller Releasing Solenoid0008-8426/ iR85+ / iR8070Before removing the deck pickup roller releasing solenoid [1], be sureto take note of the positions of the two fixing screws [2] of the solenoidwith reference to the scale on the support plate. Or, mark the position forthe solenoid itself on the support plate using a scriber.If you are replacing the solenoid on its own, be sure to secure thesolenoid exactly where the old solenoid was found.F-14-16514.8.35 Fitting the Side Guide Timing Belt of theManual Feed Tray Assembly0007-0649iR105i/iR105+ / iR9070Butt the rack plate [1] of the manual feed tray against section A (openstate).Move the slide volume [2] in the direction of B, and fit the timing belt[3] to the pulley [4].F-14-16614.8.36 Attaching the Timing Belt for the ManualFeed Tray Assembly Side Guide0008-8428/ iR85+ / iR8070[1][2][1][2]AView from A35.5±0.5mm[3][A][B][A][B]ZView from Z36±0.5mm[1][2] [1][2] [1][4][3] [1] [4] AB[2]
