Chapter 99-605) Remove the screw [4], and detach the connector cover [5].6) Disconnect the connector [6], and detach the manual feed tray unit [1]upward while it is kept open at about 90 deg.F-9-999.10.6.2 Removing the Manual Feed Tray Unit0008-8178/ iR85+ / iR80701) Remove the upper right cover.2) Open the manual feed tray unit [1].3) Remove the screw [2], and detach the door tape [3] from the machineside.4) Remove the screw [4], and detach the connector cover [5].5) Disconnect the connector [6], and detach the manual feed tray unit [1]upward while it is kept open at about 90 deg.F-9-1009.10.6.3 Fitting the Side Guide Timing Belt for the ManualFeed Tray Assembly(iR105)0007-2790iR1051) Butt the rack plate [1] of the manual feed tray against section A (inopen state).2) Move the slide volume [2] in the direction of B, and fit the timing belt[3] to the pulley [4] and the pulley [5].F-9-1019.10.6.4 Fitting the Side Guide Timing Belt for the ManualFeed Tray Assembly0008-8180iR105i/iR105+ / iR9070 / iR85+ / iR80701) Butt the rack plate [1] of the manual feed tray against section A (inopen state).2) Move the slide volume [2] in the direction of B, and fit the timing belt[3] to the pulley [4] and the pulley [5].F-9-1029.10.7 Manual Pickup Roller9.10.7.1 Removing the Pickup Roller0007-1271iR105i/iR105+ / iR9070 / iR85+ / iR80701) Open the manual tray paper guide.2) Remove the left/right stop rings [1] (two each), shutters [2] (twoeach), spacers [3] (two each), and rolls [4] (two each).F-9-103If the multifeeder is used during installation or if the multifeeder has notbeen used for a long time, pickup can fail. If such happens, detach theprotective sheet from the sponge roller, and dry wipe the sponge roller.9.10.7.2 Mounting the Pickup Roller0007-1272iR105i/iR105+ / iR9070 / iR85+ / iR8070Mount the pickup roller by reversing the steps used to remove it with thefollowing in mind:- The front pickup roller and the rear pickup roller are notinterchangeable.- The front pickup roller is identified by its silver- colored collar.When mounting the pickup roller [1] to the pickup assembly, be surethat the round marking [2] on the collar (silver) is toward themachine's front,- The rear pickup roller is identified by its gold collar.When mounting the pickup roller [3] to the pickup assembly, be surethat the round marking [4] on the side of the roller and the roundmarking [5] on its collar (gold) are toward the machine's rear.[1][6][5][4][2] [3][1][6][5][4][2] [3][4] [5][3][1] A[2]B[4] [5][3][1] A[2]B[1] [2] [3] [4] [4] [3] [2] [1]
