2-141Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandsdot1x paedot1x paeUse the dot1x pae interface configuration command on the switch stack or on a standalone switch toconfigure the port as an IEEE 802.1x port access entity (PAE) authenticator. Use the no form of thiscommand to disable IEEE 802.1x authentication on the port.dot1x pae authenticatorno dot1x paeSyntax Description This command has no arguments or keywords.Defaults The port is not an IEEE 802.1x PAE authenticator, and IEEE 802.1x authentication is disabled on theport.Command Modes Interface configurationCommand HistoryUsage Guidelines Use the no dot1x pae interface configuration command to disable IEEE 802.1x authentication on theport.When you configure IEEE 802.1x authentication on a port, such as by entering the dot1x port-controlinterface configuration command, the switch automatically configures the port as an EEE 802.1xauthenticator. After the no dot1x pae interface configuration command is entered, the AuthenticatorPAE operation is disabled.Examples This example shows how to disable IEEE 802.1x authentication on the port:Switch(config-if)# no dot1x paeYou can verify your settings by entering the show dot1x or show eap privileged EXEC command.Related CommandsRelease Modification12.2(40)EX1 This command was introduced.Command Descriptionshow dot1x Displays IEEE 802.1x statistics, administrative status, andoperational status for the switch or for the specified port.show eap Displays EAP registration and session information for theswitch or for the specified port.
