B-22Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug monitordebug monitorUse the debug monitor privileged EXEC command to enable debugging of the Switched Port Analyzer(SPAN) feature. Use the no form of this command to disable debugging.debug monitor {all | errors | idb-update | info | list | notifications | platform | requests | snmp}no debug monitor {all | errors | idb-update | info | list | notifications | platform | requests |snmp}Syntax DescriptionDefaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug monitor command is the same as the no debug monitor command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsall Display all SPAN debug messages.errors Display detailed SPAN error debug messages.idb-update Display SPAN interface description block (IDB) update-trace debug messages.info Display SPAN informational-tracing debug messages.list Display SPAN port and VLAN-list tracing debug messages.notifications Display SPAN notification debug messages.platform Display SPAN platform-tracing debug messages.requests Display SPAN request debug messages.snmp Display SPAN and Simple Network Management Protocol (SNMP) tracingdebug messages.Release Modification12.2(40)EX1 This command was introduced.Command Descriptionshow debugging Displays information about the types of debugging that are enabled.show monitor Displays information about all SPAN and remote SPAN (RSPAN) sessionson the switch.
