B-74Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug qos-managerdebug qos-managerUse the debug qos-manager privileged EXEC command to enable debugging of the quality of service(QoS) manager software. Use the no form of this command to disable debugging.debug qos-manager {all | event | verbose}no debug qos-manager {all | event | verbose}Syntax DescriptionDefaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug qos-manager command is the same as the no debug qos-manager command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsall Display all QoS-manager debug messages.event Display QoS-manager related-event debug messages.verbose Display QoS-manager detailed debug messages.Release Modification12.2(40)EX1 This command was introduced.Command Descriptionshow debugging Displays information about the types of debugging that are enabled.
