2-662Cisco Catalyst Blade Switch 3120 for HP Command ReferenceOL-12248-03Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commandsshow storm-controlshow storm-controlUse the show storm-control user EXEC command to display broadcast, multicast, or unicast stormcontrol settings on the switch or on the specified interface or to display storm-control history.show storm-control [interface-id] [broadcast | multicast | unicast] [ | {begin | exclude | include}expression]Syntax DescriptionCommand Modes User EXECCommand HistoryUsage Guidelines When you enter an interface-id, the storm control thresholds appear for the specified interface.If you do not enter an interface-id, settings appear for one traffic type for all ports on the switch.If you do not enter a traffic type, settings appear for broadcast storm control.Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain outputdo not appear, but the lines that contain Output appear.Examples This is an example of a partial output from the show storm-control command when no keywords areentered. Because no traffic-type keyword was entered, the broadcast storm control settings appear.Switch> show storm-controlInterface Filter State Upper Lower Current--------- ------------- ---------- --------- ---------Gi1/0/1 Forwarding 20 pps 10 pps 5 ppsGi1/0/2 Forwarding 50.00% 40.00% 0.00%