2-274Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandsipv6 mld snooping vlanipv6 mld snooping vlanUse the ipv6 mld snooping vlan global configuration command on the switch stack or on a standaloneswitch to configure IP version 6 (IPv6) Multicast Listener Discovery (MLD) snooping parameters on theVLAN interface. Use the no form of this command to reset the parameters to the default settings.ipv6 mld snooping vlan vlan-id [immediate-leave | mrouter interface interface-id | staticipv6-multicast-address interface interface-id]no ipv6 mld snooping vlan vlan-id [immediate-leave | mrouter interface interface-id | staticip-address interface interface-id]Note This command is supported only if you have configured a dual IPv4 and IPv6 Switch DatabaseManagement (SDM) template on the switch.Syntax DescriptionCommand Default MLD snooping Immediate-Leave processing is disabled.By default, there are no static IPv6 multicast groups.By default, there are no multicast router ports.Command Modes Global configurationCommand HistoryUsage Guidelines To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)global configuration command and reload the switch.You should only configure the Immediate-Leave feature when there is only one receiver on every port inthe VLAN. The configuration is saved in NVRAM.The static keyword is used for configuring the MLD member ports statically.vlan vlan-id Specify a VLAN number. The range is 1 to 1001 and 1006 to 4094.immediate-leave (Optional) Enable MLD Immediate-Leave processing on a VLANinterface. Use the no form of the command to disable the ImmediateLeave feature on the interface.mrouter interface (Optional) Configure a multicast router port. The no form of thecommand removes the configuration.static ipv6-multicast-address (Optional) Configure a multicast group with the specified IPv6multicast address.interface interface-id Add a Layer 2 port to the group. The mrouter or static interface can bea physical port or a port-channel interface in the range of 1 to 64.Release Modification12.2(40)EX1 This command was introduced.
