B-12Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug ip verify source packetdebug ip verify source packetUse the debug ip verify source packet privileged EXEC command to enable debugging of IP sourceguard. Use the no form of this command to disable debugging.debug ip verify source packetno debug ip verify source packetSyntax Description This command has no arguments or keywords.Defaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug ip verify source packet command is the same as the no debug ip verify source packetcommand.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related CommandsRelease Modification12.2(40)EX1 This command was introduced.Command Descriptionshow debugging Displays information about the types of debugging that areenabled.
