B-26Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug pagpdebug pagpUse the debug pagp privileged EXEC command to enable debugging of Port Aggregation Protocol(PAgP) activity. Use the no form of this command to disable debugging.debug pagp [all | dual-active | vent | fsm | misc | packet]no debug pagp [all | dual-active | event | fsm | misc | packet]Syntax DescriptionDefaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug pagp command is the same as the no debug pagp command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsall (Optional) Display all PAgP debug messages.dual-active (Optional) Dispaly dual-active detection messages.event (Optional) Display PAgP event debug messages.fsm (Optional) Display PAgP finite state-machine debug messages.misc (Optional) Display miscellaneous PAgP debug messages.packet (Optional) Display PAgP packet debug messages.Release Modification12.2(40)EX1 This command was introduced.12.2(46)SE The dual-active keyword was added.Command Descriptionshow debugging Displays information about the types of debugging that are enabled.show pagp Displays PAgP channel-group information.
