2-169Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandserrdisable recovery cause small-frameerrdisable recovery cause small-frameUse the errdisable recovery cause small-frame global configuration command on the switch stack oron a standalone switch to enable the recovery timer for ports to be automatically re-enabled after theyare error disabled by the arrival of small frames. Use the no form of this command to return to the defaultsetting.errdisable recovery cause small-frameno errdisable recovery cause small-frameSyntax Description This command has no arguments or keywords.Defaults This feature is disabled.Command Modes Global configurationCommand HistoryUsage Guidelines This command enables the recovery timer for error-disabled ports. You configure the recovery time byusing the errdisable recovery interval interval interface configuration command.Examples This example shows how to set the recovery timer:Switch(config)# errdisable recovery cause small-frameYou can verify your setting by entering the show interfaces user EXEC command.Related CommandsRelease Modification12.2(46)SE This command was introduced.Command Descriptionerrdisable detect cause small-frame Allows any switch port to be put into the error-disabledstate if an incoming frame is smaller than the configuredminimum size and arrives at the specified rate (threshold).show interfaces Displays the interface settings on the switch, includinginput and output flow control.small-frame violation rate Configures the size for an incoming (small) frame to causea port to be put into the error-disabled state.
