2-565Cisco Catalyst Blade Switch 3120 for HP Command ReferenceOL-12248-03Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commandsshow ipv6 mld snooping addressshow ipv6 mld snooping addressUse the show ipv6 mld snooping address user EXEC command to display all or specified IP Version 6(IPv6) multicast address information maintained by Multicast Listener Discovery (MLD) snooping.show ipv6 mld snooping address [[vlan vlan-id] [ipv6 address]] [vlan vlan-id] [count | dynamic| user] [ | {begin | exclude | include} expression]Note This command is supported only if you have configured a dual IPv4 and IPv6 Switch DatabaseManagement (SDM) template on the switch.Syntax DescriptionCommand Modes User EXECCommand HistoryUsage Guidelines Use this command to display IPv6 multicast address information.You can enter an IPv6 multicast address only after you enter a VLAN ID.VLAN numbers 1002 through 1005 are reserved for Token Ring and FDDI VLANs and cannot be usedin MLD snooping.Use the dynamic keyword to display information only about groups that are learned. Use the userkeyword to display information only about groups that have been configured.To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)global configuration command and reload the switch.Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain outputdo not appear, but the lines that contain Output appear.vlan vlan-id (Optional) Specify a VLAN about which to show MLD snooping multicastaddress information. The VLAN ID range is 1 to 1001 and 1006 to 4094.ipv6-multicast-address (Optional) Display information about the specified IPv6 multicast address.This keyword is only available when a VLAN ID is entered.count (Optional) Display the number of multicast groups on the switch or in thespecified VLAN.dynamic (Optional) Display MLD snooping learned group information.user (Optional) Display MLD snooping user-configured group information.| begin (Optional) Display begins with the line that matches the expression.| exclude (Optional) Display excludes lines that match the expression.| include (Optional) Display includes lines that match the specified expression.expression Expression in the output to use as a reference point.Release Modification12.2(40)EX1 This command was introduced.
