B-9Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug etherchanneldebug etherchannelUse the debug etherchannel privileged EXEC command to enable debugging of theEtherChannel/PAgP shim. This shim is the software module that is the interface between the PortAggregation Protocol (PAgP) software module and the port manager software module. Use the no formof this command to disable debugging.debug etherchannel [all | detail | error | event | idb]no debug etherchannel [all | detail | error | event | idb]Syntax DescriptionNote Though visible in the command-line help strings, the linecard keyword is not supported.Defaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines If you do not specify a keyword, all debug messages appear.The undebug etherchannel command is the same as the no debug etherchannel command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsall (Optional) Display all EtherChannel debug messages.detail (Optional) Display detailed EtherChannel debug messages.error (Optional) Display EtherChannel error debug messages.event (Optional) Debug major EtherChannel event messages.idb (Optional) Display PAgP interface descriptor block debug messages.Release Modification12.2(40)EX1 This command was introduced.Command Descriptionshow debugging Displays information about the types of debugging that are enabled.show etherchannel Displays EtherChannel information for the channel.
