B-16Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug ip igmp snoopingdebug ip igmp snoopingUse the debug igmp snooping privileged EXEC command to enable debugging of Internet GroupManagement Protocol (IGMP) snooping activity. Use the no form of this command to disabledebugging.debug ip igmp snooping [group | management | querier | router | timer]no debug ip igmp snooping [group | management | querier | router | timer]Syntax DescriptionDefaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug ip igmp snooping command is the same as the no debug ip igmp snooping command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsgroup (Optional) Display IGMP snooping group activity debug messages.management (Optional) Display IGMP snooping management activity debug messages.querier (Optional) Display IGMP snooping querier debug messages.router (Optional) Display IGMP snooping router activity debug messages.timer (Optional) Display IGMP snooping timer event debug messages.Release Modification12.2(40)EX1 This command was introduced.Command Descriptiondebug platform ipigmp snoopingDisplays information about platform-dependent IGMP snooping activity.show debugging Displays information about the types of debugging that are enabled.
