B-27Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug platform acldebug platform aclUse the debug platform acl privileged EXEC command to enable debugging of the access control list(ACL) manager. Use the no form of this command to disable debugging.debug platform acl {all | exit | label | main | racl | stack | vacl | vlmap | warn}no debug platform acl {all | exit | label | main | racl | stack | vacl | vlmap | warn}Syntax DescriptionNote Though visible in the command-line help strings, the stack keyword is not supported onnonstacking-capable switches.Command Default Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug platform acl command is the same as the no debug platform acl command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.all Display all ACL manager debug messages.exit Display ACL exit-related debug messages.label Display ACL label-related debug messages.main Display the main or important ACL debug messages.racl Display router ACL related debug messages.stack Display ACL stack-related debug messages.This keyword is supported only on stacking-capable switches.vacl Display VLAN ACL-related debug messages.vlmap Display ACL VLAN-map-related debug messages.warn Display ACL warning-related debug messages.Release Modification12.2(40)EX1 This command was introduced.
