2-440Cisco Catalyst Blade Switch 3120 for HP Command ReferenceOL-12248-03Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commandssetup expresssetup expressUse the setup express global configuration command to enable Express Setup mode on the switch stackor on a standalone switch. Use the no form of this command to disable Express Setup mode.setup expressno setup expressSyntax Description This command has no arguments or keywords.Defaults Express Setup is enabled.Command Modes Global configurationCommand HistoryUsage Guidelines When Express Setup is enabled on a new (unconfigured) switch, pressing the Mode button for 2 secondsactivates Express Setup. You can access the switch through an Ethernet port by using the IP address10.0.0.1 and then can configure the switch with the web-based Express Setup program or thecommand-line interface (CLI)-based setup program.When you press the Mode button for 2 seconds on a configured switch, the LEDs above the Mode buttonstart blinking. If you press the Mode button for a total of 10 seconds, the switch configuration is deleted,and the switch reboots. The switch can then be configured like a new switch, either through theweb-based Express Setup program or the CLI-based setup program.Note As soon as you make any change to the switch configuration (including entering no at the beginning ofthe CLI-based setup program), configuration by Express Setup is no longer available. You can only runExpress Setup again by pressing the Mode button for 10 seconds. This deletes the switch configurationand reboots the switch.If Express Setup is active on the switch, entering the write memory or copy running-configurationstartup-configuration privileged EXEC commands deactivates Express Setup. The IP address 10.0.0.1is no longer valid on the switch, and your connection using this IP address ends.The primary purpose of the no setup express command is to prevent someone from deleting the switchconfiguration by pressing the Mode button for 10 seconds.Release Modification12.2(40)EX1 This command was introduced.
