2-350Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandsmls qos srr-queue input dscp-mapmls qos srr-queue input dscp-mapUse the mls qos srr-queue input dscp-map global configuration command on the switch stack or on astandalone switch to map Differentiated Services Code Point (DSCP) values to an ingress queue or tomap DSCP values to a queue and to a threshold ID. Use the no form of this command to return to thedefault setting.mls qos srr-queue input dscp-map queue queue-id {dscp1...dscp8 | threshold threshold-iddscp1...dscp8}no mls qos srr-queue input dscp-mapSyntax DescriptionDefaults Table 2-11 shows the default DSCP input queue threshold map:Command Modes Global configurationCommand HistoryUsage Guidelines The DSCP assigned at the ingress port selects an ingress or egress queue and threshold.The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state. You canassign two weighted tail-drop (WTD) threshold percentages to an ingress queue by using the mls qossrr-queue input threshold global configuration command.queue queue-id Specify a queue number.For queue-id, the range is 1 to 2.dscp1...dscp8 Map DSCP values to an ingress queue.For dscp1...dscp8, enter up to eight values, and separate each value with aspace. The range is 0 to 63.threshold threshold-iddscp1...dscp8Map DSCP values to a queue threshold ID.For threshold-id, the range is 1 to 3.For dscp1...dscp8, enter up to eight values, and separate each value with aspace. The range is 0 to 63.Table 2-11 Default DSCP Input Queue Threshold MapDSCP Value Queue ID–Threshold ID0–39 1–140–47 2–148–63 1–1Release Modification12.2(40)EX1 This command was introduced.
