2-49Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandsboot auto-copy-swboot auto-copy-swUse the boot auto-copy-sw global configuration command from the stack master to enable the automaticupgrade (auto-upgrade) process. It automatically upgrades a switch in version-mismatch (VM) mode bycopying the running software image on any stack member or by copying a tar file image in switch stackflash memory. Use the no form of this command to disable the auto-upgrade process.boot auto-copy-swno boot auto-copy-swNote This command is supported only on stacking-capable switches.Syntax Description This command has no arguments or keywords.Defaults Enabled.Command Modes Global configurationCommand HistoryUsage Guidelines A switch in VM mode is a switch that has a different minor version number than the version on the switchstack. A switch in VM mode cannot join the switch stack as a fully functioning member. If the switchstack has an image that can be copied to a switch in VM mode, the auto-upgrade process automaticallycopies the image from a stack member to the switch in VM mode. The switch then exits VM mode,reboots, and joins the switch stack as a fully functioning member.The auto-upgrade process affects only switches in VM mode. It does not affect existing stack members.Release Modification12.2(40)EX1 This command was introduced.
