2-188Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandsip admissionip admissionUse the ip admission interface configuration command to enable web authentication. You can also usethis command in fallback-profile mode. Use the no form of this command to disable web authentication.ip admission ruleno ip admissionSyntax DescriptionCommand Modes Global configurationCommand HistoryUsage Guidelines The ip admission command applies a web authentication rule to a switch port.Examples This example shows how to apply a web authentication rule to a switchport:Switch# configure terminalSwitch(config)# interface gigabitethernet1/0/1Switch(config-if)# ip admission rule1This example shows how to apply a web authentication rule to a fallback profile for use on anIEEE 802.1x enabled switch port.Switch# configure terminalSwitch(config)# fallback profile profile1Switch(config)# ip admission name rule1Switch(config)# endRelated Commandsrule Apply an IP admission rule to the interface.Release Modification12.2(40)EX1 This command was introduced.Command Descriptiondot1x fallback Configure a port to use web authentication as a fallback method for clientsthat do not support IEEE 802.1x authentication.fallback profile Enable web authentication on a portip admission nameproxy httpEnable web authentication globally on a switchshow ip admission Displays information about NAC cached entries or the NAC configuration.For more information, see the Network Admission Control SoftwareConfiguration Guide on Cisco.com.
