2-156Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commandsenergywise domainenergywise domainUse the energywise domain global configuration command to enable EnergyWise on the entity, assignthe entity to a domain, and set the password for secure communication among the domain entities. Usethe no form of this command to disable EnergyWise and to remove the EnergyWise configuration.energywise domain domain-name secret [0 | 7] password [protocol udp port udp-port-number[interface interface-id | ip ip-address]]no energywise domainSyntax DescriptionDefaults EnergyWise is disabled, and the entity is not assigned to a domain.The password is not set.The udp-port-number is 43440.Command Modes Privileged EXECCommand Historydomain domain-name Assign the entity to a domain with the specified domain-name.• You can enter alphanumeric characters and symbols such as #, (, %, !, or&.• Do not use an asterisk (*) or a blank space between the characters andsymbols.secret [0 | 7] password Set the password for secure communication among the entities in thedomain.• (Optional) 0—Use an unencrypted password.• (Optional) 7—Use an hidden password.If you do not enter 0 or 7, the entity uses the default value of 0.• You can enter alphanumeric characters and symbols such as #, (, %, !, or&.• Do not use an asterisk (*) or a blank space between the characters andsymbols.port udp-port-number (Optional) Specify the UDP port that sends and receives queries.The range is from 1 to 65000.interface interface-id (Optional) Specify the port from which the EnergyWise messages are sent.ip ip-address (Optional) Specify the IP address from which the EnergyWise messages aresent.Release Modification12.2(50)SE This command was introduced.
