B-36Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug platform dot1xdebug platform dot1xUse the debug platform dot1x privileged EXEC command to enable debugging of IEEE 802.1x events.On stacking-capable switches, this command enables debugging of stack-related IEEE 802.1x events.Use the no form of this command to disable debugging.debug platform dot1x {initialization | interface-configuration | rpc}no debug platform dot1x {initialization | interface-configuration | rpc}Syntax DescriptionDefaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsinitialization Display IEEE 802.1x-authentication initialization sequence debugmessages.interface-configuration Display IEEE 802.1x interface configuration-related debug messages.rpc Display IEEE 802.1x remote procedure call (RPC) request debugmessages.Release Modification12.2(40)EX1 This command was introduced.Command Descriptionshow debugging Displays information about the types of debugging that are enabled.
