B-2Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug auto qosdebug auto qosUse the debug auto qos privileged EXEC command to enable debugging of the automatic quality ofservice (auto-QoS) feature. Use the no form of this command to disable debugging.debug auto qosno debug auto qosSyntax Description This command has no keywords or arguments.Defaults Auto-QoS debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines To display the QoS configuration that is automatically generated when auto-QoS is enabled, enabledebugging before you enable auto-QoS. You enable debugging by entering the debug auto qosprivileged EXEC command.The undebug auto qos command is the same as the no debug auto qos command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Examples This example shows how to display the QoS configuration that is automatically generated whenauto-QoS is enabled:Switch# debug auto qosAutoQoS debugging is onSwitch# configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)# interface gigabitethernet2/0/1Switch(config-if)# auto qos voip cisco-phone21:29:41: mls qos map cos-dscp 0 8 16 26 32 46 48 5621:29:41: mls qos21:29:42: no mls qos srr-queue input cos-map21:29:42: no mls qos srr-queue output cos-map21:29:42: mls qos srr-queue input cos-map queue 1 threshold 3 021:29:42: mls qos srr-queue input cos-map queue 1 threshold 2 1Release Modification12.2(40)EX1 This command was introduced.
