B-60Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command ReferenceOL-13271-03Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commandsdebug platform resource-managerdebug platform resource-managerUse the debug platform resource-manager privileged EXEC command to enable debugging of theresource manager software. Use the no form of this command to disable debugging.debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}no debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}Syntax DescriptionDefaults Debugging is disabled.Command Modes Privileged EXECCommand HistoryUsage Guidelines The undebug platform resource-manager command is the same as the no debug platformresource-manager command.On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. Toenable debugging on a stack member, you can start a session from the stack master by using the sessionswitch-number privileged EXEC command. Then enter the debug command at the command-lineprompt of the stack member. You also can use the remote command stack-member-number LINEprivileged EXEC command on the stack master switch to enable debugging on a member switch withoutfirst starting a session.Related Commandsall Display all resource manager debug messages.dm Display destination-map debug messages.erd Display equal-cost-route descriptor-table debug messages.errors Display error debug messages.madmed Display the MAC address descriptor table and multi-expansion descriptor tabledebug messages.sd Display the station descriptor table debug messages.stats Display statistics debug messages.vld Display the VLAN-list descriptor debug messages.Release Modification12.2(40)EX1 This command was introduced.Command Descriptionshow debugging Displays information about the types of debugging that are enabled.
