1-8Follow these steps to configure synchronous information output:To do… Use the command… RemarksEnter system view system-view —Enable synchronous informationoutput info-center synchronous RequiredDisabled by defaultz If the system information is output before you input any information following the current commandline prompt, the system does not echo any command line prompt after the system informationoutput.z In the interaction mode, you are prompted for some information input. If the input is interrupted bysystem output, no system prompt (except the Y/N string) will be echoed after the output, but yourinput will be displayed in a new line.Configuring to Display the Time Stamp with the UTC Time ZoneTo add UTC time zone to the time stamp in the information center output information, you must:z Set the local time zonez Set the time stamp format in the output destination of the information center to datez Configure to add the UTC time zone to the output informationFollow these steps to configure to display time stamp with the UTC time zone:To do… Use the command… RemarksSet the time zone for the system clock timezone zone-name{ add | minus } timeRequiredBy default, UTC time zone is set forthe system.Enter system view system-view —Log hostdirectioninfo-center timestamp loghostdateSet the time stampformat in the outputdestination of theinformation center todateNon loghostdirectioninfo-center timestamp { log |trap | debugging } dateRequiredUse either commandSet to display the UTC time zone inthe output information of theinformation centerinfo-center timestamp utcRequiredBy default, no UTC time zone isdisplayed in the output informationSetting to Output System Information to the ConsoleSetting to output system information to the consoleFollow these steps to set to output system information to the console:
