1-7Link Aggregation Configurationz The commands of link aggregation cannot be configured with the commands of port loopbackdetection feature at the same time.z The ports where the mac-address max-mac-count command is configured cannot be added toan aggregation group. Contrarily, the mac-address max-mac-count command cannot beconfigured on a port that has already been added to an aggregation group.z MAC-authentication-enabled ports and 802.1x-enabled ports cannot be added to an aggregationgroup.z Mirroring destination ports and mirroring reflector ports cannot be added to an aggregation group.z Ports configured with blackhole MAC addresses, static MAC addresses, multicast MAC addresses,or the static ARP protocol cannot be added to an aggregation group.z Ports where the IP-MAC address binding is configured cannot be added to an aggregation group.z Port-security-enabled ports cannot be added to an aggregation group.z The port with Voice VLAN enabled cannot be added to an aggregation group.z Do not add ports with the inter-VLAN MAC address replicating function of the selective QinQfeature enabled to an aggregation group.z Do not add ports with IP filtering enabled to an aggregation group.z Do not add ports with ARP intrusion detection enabled to an aggregation group.z Do not add ports with source IP addresses/source MAC addresses statically bound to them to anaggregation group.z Web-authentication-enabled ports cannot be added to an aggregation group.Configuring a Manual Aggregation GroupYou can create a manual aggregation group, or remove an existing manual aggregation group (afterthat, all the member ports will be removed from the group).For a manual aggregation group, a port can only be manually added/removed to/from the manualaggregation group.Follow these steps to configure a manual aggregation group:To do… Use the command… RemarksEnter system view system-view —Create a manual aggregationgrouplink-aggregation group agg-id modemanual RequiredEnter Ethernet port view interface interface-type interface-number —Add the Ethernet port to theaggregation group port link-aggregation group agg-id Required
