2-3You can use the following commands to enable the two switches.Follow these steps to enable debugging and terminal display for a specific module:To do… Use the command… RemarksEnable system debugging forspecific moduledebugging module-name[ debugging-option ]RequiredDisabled for all modules by default.Enable terminal display fordebugging terminal debugging RequiredDisabled by default.The output of debugging information affects the system operation. Disable all debugging after you finishthe system debugging.Displaying Debugging StatusTo do… Use the command… RemarksDisplay all enabled debugging onthe specified devicedisplay debugging [ fabric | unit unit-id ][ interface interface-type interface-number ][ module-name ]Display all enabled debugging inthe Fabric by module display debugging fabric by-moduleAvailable in anyview.Displaying Operating Information about Modules in SystemWhen an Ethernet switch is in trouble, you may need to view a lot of operating information to locate theproblem. Each functional module has its corresponding operating information display command(s). Youcan use the command here to display the current operating information about the modules in thesystem for troubleshooting your system.To do… Use the command… RemarksDisplay the currentoperation informationabout the modules in thesystem.display diagnostic-informationYou can use this command in any view.You should execute this command twice tofind the difference between the two executingresults, thus helping locate the problem.