1-8Note that:1) When creating an aggregation group:z If the aggregation group you are creating already exists but contains no port, its type will change tothe type you set.z If the aggregation group you are creating already exists and contains ports, the possible typechanges may be: changing from dynamic or static to manual, and changing from dynamic to static;and no other kinds of type change can occur.z When you change a dynamic/static group to a manual group, the system will automatically disableLACP on the member ports. When you change a dynamic group to a static group, the system willremain the member ports LACP-enabled.2) When a manual or static aggregation group contains only one port, you cannot remove the portunless you remove the whole aggregation group.Configuring a Static LACP Aggregation GroupYou can create a static LACP aggregation group, or remove an existing static LACP aggregation group(after that, the system will re-aggregate the original member ports in the group to form one or multipledynamic aggregation groups.).For a static aggregation group, a port can only be manually added/removed to/from the staticaggregation group.When you add an LACP-enabled port to a manual aggregation group, the system will automaticallydisable LACP on the port. Similarly, when you add an LACP-disabled port to a static aggregation group,the system will automatically enable LACP on the port.Follow these steps to configure a static LACP aggregation group:To do… Use the command… RemarksEnter system view system-view —Create a static aggregation group link-aggregation group agg-idmode static RequiredEnter Ethernet port view interface interface-typeinterface-number —Add the port to the aggregationgroupport link-aggregation groupagg-id Required