1-18[Sysname] acl number 2000[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255[Sysname-acl-basic-2000] quit[Sysname] interface GigabitEthernet1/0/1[Sysname-GigabitEthernet1/0/1] traffic-limit inbound ip-group 2000 128 exceedremark-dscp 56Configuring Line RateRefer to section Line Rate for information about line rate.Configuration prerequisitesz The port on which line rate configuration is to be performed has been determined.z The target rate has been determined.Configuration procedureFollow these steps to configure line rate:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure line rateline-rate outboundtarget-rate [ burst-bucketburst-bucket-size ]RequiredSpecify a committedinformation rate (CIR) for thetarget-rate argument, andspecify a committed bust size(CBS) for theburst-bucket-size argument.By default, line rate isdisabled.Configuration example# Set the line rate to 1024 kbps for outbound packets on GigabitEthernet 1/0/1. system-view[Sysname] interface GigabitEthernet1/0/1[Sysname-GigabitEthernet1/0/1] line-rate outbound 1024Configuring Traffic RedirectingRefer to section Traffic Redirecting for information about traffic redirecting.Configuration prerequisitesz The ACL rules used for traffic classification have been defined. Refer to the ACLmodule of this manual for information about defining ACL rules.z The traffic redirecting destination has been determined.z The ports that need this configuration have been determined.Configuration procedureFollow these steps to configure traffic redirecting:To do… Use the command… RemarksEnter system view system-view —
