2-8Console Port Login Configuration with Authentication Mode BeingPasswordConfiguration ProcedureFollow these steps to configure console port login with the authentication mode being password:To do… Use the command… RemarksEnter system view system-view —Enter AUX user interface view user-interface aux 0 —Configure to authenticateusers using the local passwordauthentication-modepasswordRequiredBy default, users logging in to a switchthrough the console port are notauthenticated; while those logging in throughModems or Telnet are authenticated.Set the local passwordset authenticationpassword { cipher |simple } passwordRequiredSet the baudrate speed speed-valueOptionalThe default baud rate of an AUX port (alsothe console port) is 9,600 bps.Set the checkmode parity { even | none | odd }OptionalBy default, the check mode of a console portis set to none, that is, no check bit.Set the stop bits stopbits { 1 | 1.5 | 2 } OptionalThe default stop bits of a console port is 1.Configurethe consoleportSet the data bits databits { 7 | 8 } OptionalThe default data bits of a console port is 8.Configure the command levelavailable to users logging in tothe user interfaceuser privilege level levelOptionalBy default, commands of level 3 are availableto users logging in to the AUX user interface.Make terminal servicesavailable to the user interface shellOptionalBy default, terminal services are available inall user interfaces.Set the maximum number oflines the screen can containscreen-lengthscreen-lengthOptionalBy default, the screen can contain up to 24lines.You can use the screen-length 0 commandto disable the function to display informationin pages.Set history command buffersizehistory-commandmax-size valueOptionalThe default history command buffer size is10. That is, a history command buffer canstore up to 10 commands by default.
