1-8To do… Use the command… RemarksConfigure the priority of the VRRPgroupvrrp vrid virtual-router-id prioritypriorityOptional100 by default.It is not recommended to configure features related to VRRP group on the Layer 3 interface of aremote-probe VLAN. Otherwise, packet mirroring may be affected.Configuring Advanced VRRP FunctionsComplete these tasks to configure advanced VRRP functionsTask RemarksConfiguring the preemptive mode and preemption delay fora switch OptionalConfiguring VRRP authentication type and authenticationkey for a member switch OptionalConfiguring VRRP timer OptionalAdvanced VRRPconfigurationConfiguring VRRP Tracking OptionalConfiguring the preemptive mode and preemption delay for a switchTo do… Use the command… RemarksEnter system view system-view —Enter VLAN interface view interface Vlan-interface vlan-id —Configure a virtual router IPaddressvrrp vrid virtual-router-idvirtual-ip virtual-address RequiredConfigure the preemptive modeand preemption delay for theswitches in the VRRP groupvrrp vrid virtual-router-idpreempt-mode [ timer delaydelay-value ]RequiredBy default, preemptive mode is setfor the VRRP group and thepreemption delay is 0 seconds.Configuring VRRP authentication type and authentication key for a member switchTo do… Use the command… RemarksEnter system view system-view —Enter VLAN interface view interface Vlan-interface vlan-id —Configure a virtual router IPaddressvrrp vrid virtual-router-id virtual-ipvirtual-address RequiredConfigure the authentication typeand authentication keyvrrp vrid virtual-router-idauthentication-modeauthentication-typeauthentication-keyOptionalNo authentication is performed bydefault.