1-6Follow these steps to configure PoE over-temperature protection on the switch:To do… Use the command… RemarksEnter system view system-view —Enable PoE over-temperatureprotection on the switchpoe temperature-protectionenableOptionalEnabled by default.z When the internal temperature of the switch decreases from X (X>65°C, or X>149°F) to Y(60°C≤Y<65°C, or 140°F≤Y<149°F), the switch still keeps the PoE function disabled on all theports.z When the internal temperature of the switch increases from X (X<60°C, or X<140°F) to Y(60°C≤65°C, or 140°F≤149°F), the switch still keeps the PoE function enabled on all theports.Upgrading the PSE Processing Software OnlineThe online upgrading of PSE processing software can update the processing software or repair thesoftware if it is damaged. Before performing the following configuration, download the PSE processingsoftware to the Flash of the switch.Follow these steps to upgrade PSE processing software online:To do… Use the command… RemarksEnter system view system-view —Upgrade the PSEprocessing software onlinepoe update { refresh | full }filenameRequiredThe specified PSE processing software isa file with the extension .s19.z In the case that the PSE processing software is damaged (that is, no PoE command can beexecuted successfully), use the full update mode to upgrade and thus restore the software.z The refresh update mode is to upgrade the original processing software in the PSE throughrefreshing the software, while the full update mode is to delete the original processing software inPSE completely and then reload the software.z Generally, the refresh update mode is used to upgrade the PSE processing software.z When the online upgrading procedure is interrupted for some unexpected reason (for example, thedevice restarts due to some errors), if the upgrade in full mode fails after restart, you must upgradein full mode after power-off and restart of the device, and then restart the device manually. In thisway, the former PoE configuration is restored.
