1-10Follow these steps to enable the system information display on the console:To do… Use the command… RemarksEnable the debugging/log/trapinformation terminal display function terminal monitor OptionalEnabled by default.Enable debugging information terminaldisplay function terminal debugging OptionalDisabled by default.Enable log information terminal displayfunction terminal logging OptionalEnabled by default.Enable trap information terminal displayfunction terminal trapping OptionalEnabled by default.Make sure that the debugging/log/trap information terminal display function is enabled (use theterminal monitor command) before you enable the corresponding terminal display function by usingthe terminal debugging, terminal logging, or terminal trapping command.Setting to Output System Information to a Monitor TerminalSystem information can also be output to a monitor terminal, which is a user terminal that has loginconnections through the AUX, or VTY user interface.Setting to output system information to a monitor terminalFollow these steps to set to output system information to a monitor terminal:To do… Use the command… RemarksEnter system view system-view —Enable the informationcenter info-center enable OptionalEnabled by default.Enable systeminformation output toTelnet terminal or dumbterminalinfo-center monitor channel{ channel-number | channel-name }OptionalBy default, a switch outputslog/debugging/trap information to auser terminal through informationchannel 1.Configure the outputrules of systeminformationinfo-center source { modu-name |default } channel { channel-number |channel-name } [ { log | trap | debug }{ level severity | state state } ]*OptionalRefer to Table 1-4 for the defaultoutput rules of system information.Set the format of timestamp in the outputinformationinfo-center timestamp { log | trap |debugging } { boot | date | none }OptionalBy default, the time stamp format ofthe log and trap output information isdate, and that of the debuggingoutput information is boot.
