1-20Configuration procedureFollow these steps to configure VLAN mapping:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure VLAN mappingtraffic-remark-vlanidinbound acl-rule remark-vlanremark-vlanidRequiredBy default, VLAN mapping isnot configured.Configuration example# Configure a VLAN mapping on GigabitEthernet 1/0/1 to set the VLAN ID to 1001 forpackets matching Layer-2 ACL 4000. system-view[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet1/0/1] traffic-remark-vlanid inbound link-group 4000remark-vlan 1001Configuring Queue SchedulingRefer to section Queue Scheduling for information about queue scheduling.Configuration prerequisitesThe algorithm for queue scheduling to be used and the related parameters have beendetermined.Configuration procedureYou can configure queue scheduling in system view or in Ethernet port view.1) In system viewFollow these steps to configure queue scheduling in system view:To do… Use the command… RemarksEnter system view system-view —Configure queueschedulingqueue-scheduler { strict-priority |wrr queue0-weight queue1-weightqueue2-weight queue3-weightqueue4-weight queue5-weightqueue6-weight queue7-weight }RequiredBy default, the queuescheduling algorithm adoptedon all the ports is WRR. Thedefault weights of the eightoutput queues of a port are 1,2, 3, 4, 5, 9, 13, and 15 (in theorder queue 0 through queue7).2) In Ethernet port viewFollow these steps to configure queue scheduling in Ethernet port view:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —
