6-12To do... Use the command... RemarksConfigure the current port as astatic member port for amulticast group in a VLANmulticast static-groupgroup-address vlan vlan-idRequiredBy default, no port is configured as astatic multicast group member port.In VLAN interface viewFollow these steps to configure a static multicast group member port in VLAN interface view:To do... Use the command... RemarksEnter system view system-view —Enter VLAN interface view interface vlan-interfaceinterface-number —Configure specified port(s) asstatic member port(s) of a multicastgroup in the VLANmulticast static-groupgroup-address interfaceinterface-listRequiredBy default, no port is configured asa static multicast group memberport.z You can configure up to 200 static member ports on an S5600 series switch.z If a port has been configured as an IRF fabric port or a reflect port, it cannot be configured as astatic member port.Configuring a Static Router PortIn a network where the topology is unlikely to change, you can configure a port on the switch as a staticrouter port, so that the switch has a static connection to a multicast router and receives IGMP messagesfrom that router.In Ethernet port viewFollow these steps to configure a static router port in Ethernet port view:To do... Use the command... RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the current port as astatic router portmulticast static-router-port vlanvlan-idRequiredBy default, no static router port isconfigured.In VLAN viewFollow these steps to configure a static router port in VLAN view:To do... Use the command... RemarksEnter system view system-view —
