1-12Follow these steps to configure the attempts to send an NS message for duplicate address detection:To do… Use the command… RemarksEnter system view system-view —Enter VLAN interface view interface interface-typeinterface-number —Configure the attempts to send anNS message for duplicate addressdetectionipv6 nd dad attempts valueOptional1 by default. When the valueargument is set to 0, the duplicateaddress detection is disabled.Configuring the NS IntervalAfter a device sends an NS message, if it does not receive a response within a specific period, thedevice will send another NS message. You can configure the interval for sending NS messages.Follow these steps to configure the NS interval:To do… Use the command… RemarksEnter system view system-view —Enter VLAN interface view interface interface-typeinterface-number —Specify the NS interval ipv6 nd ns retrans-timer value Optional1,000 milliseconds by default.Configuring the neighbor reachable timeout time on an interfaceAfter a neighbor passed the reachability detection, the device considers the neighbor to be reachable ina specific period. However, the device will examine whether the neighbor is reachable again when thereis a need to send packets to the neighbor after the neighbor reachable timeout time elapsed.Follow these steps to configure the neighbor reachable timeout time on an interface:To do… Use the command… RemarksEnter system view system-view —Enter VLAN interface view interface interface-typeinterface-number —Configure the neighbor reachabletimeout timeipv6 nd nud reachable-timevalueOptional30,000 milliseconds by default.Configuring a Static IPv6 RouteYou can configure static IPv6 routes for network interconnection in a small sized IPv6 network.Follow these steps to configure a static IPv6 route:To do… Use the command… RemarksEnter system view system-view —Configure a static IPv6 routeipv6 route-static ipv6-addressprefix-length [ interface-typeinterface-number]nexthop-addressRequiredBy default, no static IPv6 route isconfigured.