1-31Index Response Status LastRC Time1 10 1 0 2000-04-03 08:57:20.02 10 1 0 2000-04-03 08:57:20.03 10 1 0 2000-04-03 08:57:20.04 10 1 0 2000-04-03 08:57:19.95 9 1 0 2000-04-03 08:57:19.96 11 1 0 2000-04-03 08:57:19.97 10 1 0 2000-04-03 08:57:19.98 10 1 0 2000-04-03 08:57:19.99 10 1 0 2000-04-03 08:57:19.810 10 1 0 2000-04-03 08:57:19.8For detailed output description, see the corresponding command manual.TCP Test (Tcpprivate Test) on the Specified PortsNetwork requirementsBoth the HWPing client and the HWPing server are H3C S5600 series Ethernet switches. Perform anHWPing Tcpprivate test to test time required to establish a TCP connection between this end (Switch A)and the specified destination end (Switch B), with the port number set to 8000.Network diagramFigure 1-8 Network diagram for the Tcpprivate testConfiguration procedurez Configure HWPing Server (Switch B):# Enable the HWPing server and configure the IP address and port to listen on. system-view[Sysname] hwping-server enable[Sysname] hwping-server tcpconnect 10.2.2.2 8000z Configure HWPing Client (Switch A):# Enable the HWPing client. system-view[Sysname] hwping-agent enable# Create an HWPing test group, setting the administrator name to administrator and test tag totcpprivate.[Sysname] hwping administrator tcpprivate# Configure the test type as tcpprivate.[Sysname-hwping-administrator-tcpprivate] test-type tcpprivate# Configure the IP address of the HWPing server as 10.2.2.2.[Sysname-hwping-administrator-tcpprivate] destination-ip 10.2.2.2# Configure the destination port on the HWPing server.[Sysname-hwping-administrator-tcpprivate] destination-port 8000# Configure to make 10 probes per test.
