1-11To do … Use the command … RemarksSet the port state changedelay link-delay delay-timeRequiredDefaults to 0, which indicates that no delay isintroduced.The delay configured in this way does not take effect for ports in DLDP down state. For informationabout the DLDP down state, refer to DLDP.Displaying and Maintaining Basic Port ConfigurationTo do... Use the command... RemarksDisplay port configurationinformationdisplay interface [ interface-type |interface-type interface-number ] Available in any viewDisplay the enable/disable statusof port loopback detection display loopback-detection Available in any viewDisplay the information about theports with the link-delay commandconfigureddisplay link-delay Available in any viewDisplay brief information about portconfigurationdisplay brief interface [ interface-typeinterface-number ] [ | { begin | include |exclude } string ]Available in any viewDisplay the combo ports display port combo Available in any viewDisplay the storm controlconfigurations.display storm-constrain [ interfaceinterface-type interface-number ] [ | { begin |exclude | include } regular-expression ]Available in any viewDisplay port information about aspecified unit display unit unit-id interface Available in any viewDisplay port loopback detectioninformation display loopback-detection Available in any viewDisplay the statistics on droppedpacketsdisplay packet-drop { interface[ interface-type interface-number ] |summary }Available in any viewClear port statistics reset counters interface [ interface-type |interface-type interface-number ] Available in user viewClear the statistics on droppedpacketsreset packet-drop interface[ interface-type interface-number ] Available in user viewEthernet Port Configuration ExampleNetwork requirementsz Switch A and Switch B are connected to each other through two trunk port (GigabitEthernet1/0/1).z Configure the default VLAN ID of both GigabitEthernet1/0/1 to 100.
