1-5Configuration procedureFollow these steps to enable GVRP:To do ... Use the command ... RemarksEnter system view system-view —Enable GVRP globally gvrpRequiredBy default, GVRP is disabledglobally.Enter Ethernet port view interface interface-typeinterface-number —Enable GVRP on the port gvrpRequiredBy default, GVRP is disabled onthe port.z After you enable GVRP on a trunk port, you cannot change the port to a different type.z Use the port trunk permit all command to permit the traffic of all dynamically registered VLANs topass through a trunk port with GVRP enabled.Configuring GVRP TimersFollow these steps to configure GVRP timers:To do ... Use the command ... RemarksEnter system view system-view —Configure the LeaveAll timer garp timer leaveall timer-valueOptionalBy default, the LeaveAll timer is setto 1,000 centiseconds.Enter Ethernet port view interface interface-typeinterface-number —Configure the Hold, Join, andLeave timersgarp timer { hold | join | leave }timer-valueOptionalBy default, the Hold, Join, andLeave timers are set to 10, 20, and60 centiseconds respectively.Note that:z The setting of each timer must be a multiple of 5 (in centiseconds).z The timeout ranges of the timers vary depending on the timeout values you set for other timers. Ifyou want to set the timeout time of a timer to a value out of the current range, you can set thetimeout time of the associated timer to another value to change the timeout range of this timer.The following table describes the relations between the timers: