9.2 Recording Received Audio Automatically (Auto Recording)Auto Recording is the function to record transmitted or received audio automatically to the internal memory or to a microSDcard. This function is used if the audio needs to be listened again after a part of the conversation is missed, or if the previousconversation needs to be kept as a record.If a microSD card is mounted on the transceiver and the “ ” icon appears, the audio is recorded to the microSD card. If nomicroSD card is mounted on the transceiver, the audio is recorded to the internal memory.To use this function, Auto Recording needs to be enabled by using KPG-D1/ D1N, and the method to start recording needsto be configured in Recording Type.The transceiver starts recording as follows according to the configuration in Recording Type:Table 9-4 Recording TypeConfiguration DescriptionAll TX/RX AudioIf transmission or reception starts, the audio is recorded to the internal memory or a microSD card. Ifthe recording starts, the timer for Maximum Recording Length is activated. When the amount of timeconfigured in Maximum Recording Length elapses while recording, the recording ends.Individual CallIf an Individual Call to the own transceiver is received and enters the matching state, the audio is recordedto the internal memory or a microSD card. If the recording starts, the timer for Maximum RecordingLength is activated. When the amount of time configured in Maximum Recording Length elapses whilerecording, the recording ends.After the recording ends, while in the matching state, if an Individual Call from the same transceiver isreceived or if Talkback is activated, the recording does not start. However, if an Individual Call from adifferent transceiver to the own transceiver is received, the recording starts.The matching state indicates the following states:MDC-1200/ FleetSync/ NXDN Conventional/ DMR Conventional:The state that Optional Signaling matchesNXDN Trunking/ P25 Conventional/ P25 Trunking:The state that the ID Name or Unit ID of the transmitting transceiver is displayed2-tone/ DTMF:The state that the 2-tone or DTMF code is received, and the Optional Signaling matchesFor 5-tone, the transceiver starts recording to the internal memory or microSD card if audio soundsfrom the speaker after the 5-tone sequence matches and Decode Format (MONF, MONO) is executed.Note0 Maximum Recording Length is the maximum length of time for Auto Recording to record a single session. (Refer toConfiguring Recording Time (Maximum Recording Length).)Transceiver behaviorCautionDo not disconnect the power source of the transceiver or remove the microSD card from the transceiver while theaudio is recorded to the microSD card. Also, for Portable, be careful that the remaining battery power does not runout. The data may not be stored, or the data may be damaged.Each screen is an example of the display when an Individual Call in an NXDN Conventional system is received and thereceived audio is recorded to a microSD card.9 STORING RECORDED AUDIO/ GPS DATA9.2 Recording Received Audio Automatically (Auto Recording)Common FUNC (K, F)/Ver 2.20 160CONTENTS INDEX
