Configuring the DIP SwitchThe configuration of the DIP switch is important for making a system in a Multi RF Deck/ Multi Control Head structure behaveproperly. KRK-14H (Remote Kit for Head), KRK-15B (Remote Kit for RF Deck), and KCH-20R (Featured Panel) are equippedwith the DIP switch. The DIP switch is the switch for managing the order of RF Decks and Control Heads connected in thesystem and for determining the terminal of CAN (Controller Area Network) communication. The purpose of each switch isas follows:Table 16-1 DIP SwitchDIP Switch KCH-20R/ KRK-14H(Control Head Side)KRK-15B(RF Deck Side)SW1 Not used For the terminal of CAN communicationSW2 Not used Not usedSW3 Not usedFor the numbering of RF DecksSW4 For the numbering of Control HeadsThe numbering of RF Decks and Control Heads by using the DIP switch is important to structuring Multi RF Deck/ MultiControl Head. If the RF Decks and Control Heads are not numbered correctly, the system may not start up properly. Numberthe RF Decks and Control Heads based on the following conditions, and correctly configure the DIP switch.0 The Control Head to be connected to RF Deck 1 is Control Head 1.0 The Control Head to be connected to RF Deck 3 is Control Head 2.0 No Control Head is connected to RF Deck 2.RF Deck 1Control Head 1RF Deck 2 RF Deck 3Control Head 2KRK-15B KRK-15B KRK-15BFigure 16-15 DIP Switch Configuration16 MULTI RF DECK/ MULTI CONTROL HEAD16.4 Configuring the Initial ConfigurationCommon FUNC (K, F)/Ver 2.20 258CONTENTS INDEX
